- This topic has 1 reply, 1 voice, and was last updated 1 month, 3 weeks ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
V3.33 is out. I think it is getting closer to what I envisioned as to ASCE 74. The V3.33 instruction manual is on the PulCalc page on the website.
Cheers
Peter
A note on FRP Connections:
I address Pull Through, Pin Bearing, Net Tension and Shear Out in V3.xx. There are lots of variations that cannot be addressed in one shot. There is more such as cleavage and different bolting arrangements. Let me know if I should update the connections.Also keep in mind I can make customer calculators (spread sheets) for a specific manufacturer. I recently did just that for a USA pultruder.
Peter
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.